Body Control Module: Service and Repair

BODY CONTROL MODULE REPLACEMENT

REMOVAL PROCEDURE
1. Disconnect the negative battery cable.

IMPORTANT: You must perform the new body control module (BCM) setup when replacing the BCM.

2. Remove the console accessory wiring junction block.




3. Rotate the BCM retaining lever (1) to release the BCM from the console accessory wiring junction block.
4. Remove the BCM (2) from the console accessory wiring junction block.

INSTALLATION PROCEDURE




1. Install the BCM (1) onto the console accessory wiring junction block.

IMPORTANT: Align the BCM to the console accessory wiring junction block.

2. Rotate the BCM retaining lever (2) to secure the BCM to the console accessory wiring junction block.
3. Install the console accessory wiring junction block.
4. Connect the negative battery cable.
5. Perform the new BCM setup. Programming and Relearning