Fuse Block: Service and Repair
UNDERHOOD ELECTRICAL CENTER OR JUNCTION BLOCK REPLACEMENTREMOVAL PROCEDURE
1. Open the hood.
2. Disconnect the negative battery cable from the battery.
3. Remove the air cleaner mounting bracket.
4. Remove the push-in retainer (3) from the electrical center.
5. Remove the electrical center from the inner fender.
6. Turn the electrical center over and remove the bottom cover.
7. Remove the four plastic wire retainers.
8. Label and remove the wires.
NOTE: Note the correct routing of the electrical wiring. Failure to reinstall the wiring properly could result in damage to the wiring.
9. Turn the electrical center right side up and remove the fuses and relays.
10. Remove the electrical center from the vehicle.
INSTALLATION PROCEDURE
1. Position the electrical center in the vehicle.
2. Install the fuses and relays.
3. Turn the electrical center over and install the wires.
4. Install the four plastic wire retainers.
5. Install the bottom cover to the electrical center.
6. Install the electrical center to the inner fender.
7. Install the push-in retainer (3) to the electrical center.
8. Install the air cleaner mounting bracket.
9. Connect the negative battery cable to the battery.
10. Close the hood.