Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Install the cruise control servo (1) and bracket to the vehicle. Secure the servo and bracket with the 2 bolts (2).
Tighten: Tighten the cruise control servo mounting bolts to 6.0 N.m (52 lb in).
- Connect the cruise control servo electrical connector (3).
- Install the cruise control servo cable (4) to the servo lever (1) and bracket. Secure the cruise control cable servo cable bracket with the one screw (5).
- Install the accelerator control cable (3) to the servo lever (1) and bracket.
- Adjust the cable adjusting locknuts (2) to allow slight freedom of movement between the accelerator control cable (3) and the servo lever (1).
- Secure the accelerator cable locknuts (2).
Tighten: Tighten the accelerator cable adjusting locknuts to 8 N.m (71 lb in).
- Install the cruise control servo cover (1) make sure the tabs (2) snap in place.
NOTE:
Refer to Fastener Notice in Cautions and Notices.