Scan Tool Data Definitions

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

The SIR scan tool data definitions contain a brief description of all SIR related parameters available on the scan tool. The parameters that are available on the scan tool are listed below in alphabetical order.

8 Digit GM Part Number: The scan tool displays an 8 digit part number. This number is the GM part number that is stored within the SDM memory.
Calibration ID: The scan tool displays a 4 digit number. This calibration ID is the check sum of the SDM read only memory contents.
Component Serial Number: The scan tool displays the SDM serial number.
Driver Side Belt Status: The scan tool displays Buckled or Unbuckled. The signal from the driver seat belt switch indicates whether the driver seat is buckled or unbuckled.
Driver Side Impact Sensor ID: The scan tool displays a 2 digit ID number. The ID signal is sent to the SDM from the Driver SIS.
Electronic Front End Sensor 1 ID: The scan tool displays a 2 digit ID number. The ID signal is sent to the SDM from the front end sensor.
Electronic Front End Sensor 2 ID: The scan tool displays a 2 digit ID number. The ID signal is sent to the SDM from the front end sensor.
Ignition Voltage: The scan tool displays 0-20 volts. The Ignition represents the system voltage measured by the SDM at its ignition feed.
Julian Date of Build: The scan tool displays a 3 digit number. Which represents the day of the year the module was built.
Passenger Side Impact Sensor ID: The scan tool displays a 2 digit ID number. The ID signal is sent to the SDM from the Passenger SIS.
ROM ID: The scan tool displays a 4 digit number. This number is the read-only memory (PROM) ID.
Year Module Built: The scan tool displays what year the module was built.