LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Body Rear End) >> Repair Instructions >> Module Rear Body Control Replacement - Endgate >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Rear Body Control Module
    GM1229154Courtesy of GENERAL MOTORS CORP.
  1. Install the rear BCM (1) to the endgate.
  2. Connect the electrical connectors to the module.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the screws (2) retaining the rear BCM to the endgate.

    Tighten:  Tighten the rear BCM screws to 2.5 N.m (22 lb in).

  4. Install the trim panel to the endgate. Refer to Trim Panel Replacement - Endgate (Envoy XUV) .
scientia non olet · About LEMON Manuals