LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Body Rear End) >> Repair Instructions >> Window Replacement - Endgate >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Endgate Window
    GM902609Courtesy of GENERAL MOTORS CORP.
  1. Install the endgate window to the endgate. Ensure the window is engaged in the run channels.
  2. Install the window clips (1) down onto the regulator carrier plates.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the bolts (2) retaining the window to the regulator carrier plates.

    Tighten:  Tighten the window bolts to 12 N.m (106 lb in).

  4. Connect the electrical connectors to the defogger grid on the endgate window.
  5. Install the inner reinforcement panel. Refer to Reinforcement Inner Panel Replacement - Endgate .
  6. Install the interior trim panel. Refer to Trim Panel Replacement - Endgate (Envoy XUV) .
  7. Install the endgate window outer sealing strip. Refer to Sealing Strip Replacement - Endgate Window - Outer .
scientia non olet · About LEMON Manuals