Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Install the lower control arm.
Install the rear axle lower control arm to the frame mounting nut and bolt.

Fig 1: Removing/Installing Rear Axle Lower Control Arm-To-Frame Mounting Bolt
Courtesy of GENERAL MOTORS CORP.

Fig 2: Removing/Installing Rear Axle Lower Control Arm-To-Axle Mounting Bolt

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the rear axle lower control arm to the axle mounting bolt and nut.
Tighten: Tighten the lower control arm mounting bolts to 100 N.m (74 lb ft).
Remove the rear axle support.
Lower the vehicle.