Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Install the rear axle upper control arm.
Install the rear axle upper control arm to frame mounting bolt.

Fig 1: Removing/Installing Rear Axle Upper Control Arm-To-Frame Mounting Bolt
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 2: Removing/Installing Rear Axle Upper Control Arm-To-Axle Mounting Bolt

Courtesy of GENERAL MOTORS CORP.

Install the rear axle upper control arm to axle mounting nut and bolt.
Tighten: Tighten the rear axle upper control arm mounting bolts to 131 N.m (97 lb ft).

Fig 3: Disconnecting/Connecting Air Suspension Leveling Sensor Link

Courtesy of GENERAL MOTORS CORP.

If equipped with air suspension, connect the air suspension leveling sensor link to the rear axle upper control arm.
Remove the rear axle support.
Install the wheelhouse panel. Refer to Wheelhouse Panel Replacement in Body Rear End.
Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
Lower the vehicle.