LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 199 (Engine Control System 3.4L (Introduction)) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the left inner fender brace. Refer to Brace Replacement - Front Fender Upper Diagonal in Body Front End.
  2. Remove the air cleaner intake duct. Refer to Air Cleaner Intake Duct Replacement .
  3. Remove the 2 screws (2) from the air cleaner housing sections.
  4. Remove the air cleaner housing cover assembly (1).
  5. Without disconnecting the powertrain control module (PCM) electrical connectors, remove the PCM (4) and the wiring harness from the air cleaner housing (3).
    6. Fig 1: View Of Air Cleaner Housing, Bolts, PCM & Harness
    GM444496Courtesy of GENERAL MOTORS CORP.
  6. Remove the air cleaner housing (1) by pulling the housing from the 2 rubber grommets (2) in the engine compartment.
  7. Inspect the air cleaner housing assembly for damage, replace if necessary.
    8. Fig 2: Removing Air Cleaner Housing
    GM444479Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals