LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 210 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Instrument Panel Module Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 5 .
  2. Remove the instrument panel (I/P) upper trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper (Impala) or Trim Pad Replacement - Instrument Panel (I/P) Upper (Monte Carlo) in Instrument Panel, Gages and Console.
  3. Remove the connector position assurance (CPA) from the yellow 2-way wiring harness connector on the inflatable restraint I/P module.
  4. Disconnect the harness connector from the I/P module.
    5. Fig 1: Disconnecting I/P Module Harness Connector
    GM300144Courtesy of GENERAL MOTORS CORP.
  5. Remove the I/P module mounting fasteners (3).
  6. Remove the I/P module (1) from the cross-car beam (2).
  7. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .
    8. Fig 2: Removing I/P Module
    GM300145Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals