LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 210 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Side Impact Module Replacement - Front >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the module (1) to the seat while guiding the pigtail harness through the trim cup.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the driver side air bag fasteners (2).

    Tighten:  Tighten the fasteners to 10 N.m (89 lb in).

  3. Gently pull the wiring harness (4) down into the seat cushion while guiding the harness through the wire triangle of the seat frame.
  4. Install the harness retaining clips to the seat frame.
  5. Install the seat back cover. Refer to Seat Back Cover Replacement - Front in Seats.
  6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 7 .
    7. Fig 1: Inflatable Restraint Side Impact Module & Components - Front
    GM307452Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals