LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 268 (Sunroof System) >> Repair Instructions >> Sunroof Track Timing/Synchronization (PES) >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the sunroof window. Refer to Sunroof Window Replacement .

    Tighten:  Tighten the screws to 4 N.m (35 lb in).

    2. IMPORTANT: Before installing the sunroof opening position switch, inspect the timing window. The small hole must be in line with the bar, as shown. If the hole is not aligned with the bar, rotate the gear by hand left or right until the hole and the bar are in position.
  2. Install the control module.
    3. Fig 1: Installing Control Module
    GM1542796Courtesy of GENERAL MOTORS CORP.
  3. Install the motor/actuator. Refer to Sunroof Motor/Actuator Replacement (PES) .
  4. Remove the pin that was installed to temporarily hold the position of the sunroof opening position switch.

    Tighten:  Tighten the motor attachment screws to 3.5 N.m (31 lb in).

    5. Fig 2: Sunroof Opening Position Switch
    GM1542794Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connector to the motor/actuator.
  6. Install the headliner.
    IMPORTANT: If the sunroof does not function properly, and the guides are parallel, then replace the sunroof opening switch.
  7. Verify the operation of the sunroof.
scientia non olet · About LEMON Manuals