Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Care should be taken to avoid chipping or scratching the coating when handling the suspension coil spring. Damage to the coating can cause premature failure.

Fig 1: Strut To Knuckle Bolts

Courtesy of GENERAL MOTORS CORP.

Install the strut into place.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the strut to knuckle bolts.
Tighten: Tighten the strut to knuckle bolts and nuts to 120 N.m (89 lb ft).

Fig 2: Connecting Stabilizer Shaft Link To Strut

Courtesy of GENERAL MOTORS CORP.

Connect the stabilizer shaft link to the strut. Refer to Stabilizer Shaft Link Replacement .
Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.

Fig 3: Strut-To-Body Mount Nuts

Courtesy of GENERAL MOTORS CORP.

Install strut to body mount nuts (1).
Tighten: Tighten the strut to body mount nuts to 45 N.m (33 lb ft).
Lower the vehicle.
Adjust the rear wheel alignment. Refer to Wheel Alignment Specifications in Wheel Alignment.