Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Generator Bolts & Generator

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the generator.
Install the generator bolts.
Tighten: Tighten the generator bolts to 50 N.m (37 lb ft).

Fig 2: Generator Electrical Connector Engine Harness Terminal

Courtesy of GENERAL MOTORS CORP.

Install the engine harness terminal to the generator:
1. Install the engine harness terminal to the stud.
2. Install the engine harness cable nut (3).
  Tighten: Tighten the engine harness cable nut to 13 N.m (10 lb ft).
3. Slide the boot over the generator stud.
Connect the generator electrical connector (1).

Fig 3: Positive & Negative Battery Cable

Courtesy of GENERAL MOTORS CORP.

Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory in Engine Mechanical - 5.7 L.