LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 331 (Lighting Systems) >> Repair Instructions >> Fog Lamp Replacement - Front >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Fog Lamp To Front Bumper Impact Bar
    GM64632Courtesy of GENERAL MOTORS CORP.
  1. Position the front fog lamp to the front bumper impact bar.

    Insert the fog lamp bracket alignment tab into the hole on the front bumper impact bar.

    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the front fog lamp mounting bolt to the front bumper impact bar.

    Tighten:  Tighten the front fog lamp mounting bolt to 2 N.m (18 lb in).

    3. Fig 2: Front Fog Lamp Electrical Connector To Fog Lamp Bulb/Socket
    GM64629Courtesy of GENERAL MOTORS CORP.
  3. Connect the front fog lamp electrical connector to the fog lamp bulb/socket.
    4. Fig 3: Brake Caliper Cooling Duct To Front Fascia
    GM171878Courtesy of GENERAL MOTORS CORP.
  4. Position the brake caliper cooling duct to the front fascia, and press to secure.
  5. Install the front fascia lower close out panel. Refer to Close Out Panel - Front Bumper Fascia Lower in Bumpers.
  6. Lower the vehicle.
  7. Check and adjust fog lamp aim as necessary. Refer to Fog Lamp Aiming Procedure .
scientia non olet · About LEMON Manuals