Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Install the yaw rate sensor (2) onto the bracket.

Fig 1: Installing Yaw Rate Sensor
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE .
Install the yaw rate sensor mounting bolts (1).
Tighten

Tighten the nuts to 7 N.m (62 lb in).
Connect the yaw rate sensor electrical connector.
Install the IP accessory trim plate. Refer to TRIM PLATE REPLACEMENT - INSTRUMENT PANEL (I/P) ACCESSORY in Instrument Panel, Gages and Console.
Turn the ignition switch to the ON position, engine off.
Perform the DIAGNOSTIC SYSTEM CHECK - ABS .