Installation Procedure

Fig 1: View Of Radio Electrical/Audio/Coaxial Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Connect the electrical/audio connectors to the radio.
IMPORTANT: If the radio locator tab is difficult to align to the I/P locator opening, pull the radio toward you and reposition the antenna cable.
Install the radio to the I/P.
Align the radio control locator tab to the I/P locator hole while carefully pressing the radio into the I/P until fully seated.

NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the radio screws.
Tighten: Tighten the radio screws to 2.5 N.m (22 lb in).

Fig 2: Identifying Radio Screws
Courtesy of GENERAL MOTORS CORP.
Install the I/P accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory (Aztek) or to Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Aztek) or Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Rendezvous) in Instrument Panel, Gages and Console.
Perform the radio set-up procedure. Refer to Radio Setup .