Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Do not reuse the old mounting screws. Always install new mounting screws with the new EBCM.

Fig 1: EBCM Mounting Screws

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.

Install EBCM on to the BPMV.

NOTE: Refer to Component Fastener Tightening Notice in Cautions and Notices.

Install the 4 new T-25 TORX® screws in the EBCM.
Tighten: Tighten the 4 T-25 TORX® screws to 5 N.m (39 lb in) in an X-pattern.

Fig 2: EBCM Side Connectors

Courtesy of GENERAL MOTORS CORP.

Install the 2 electrical connectors on the side of the EBCM.

Fig 3: EBCM Back Connector

Courtesy of GENERAL MOTORS CORP.

Install the electrical connector on the back of the EBCM.
Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
Revise the tire calibration using the Scan Tool Tire Size Calibration function.