LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2004 >> Sunfire Standard >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Repair Instructions >> Cruise Control Cable Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    IMPORTANT: The ribbon must not be twisted.
    Fig 1: Installing Cruise Control Cable
    GM792961Courtesy of GENERAL MOTORS CORP.
  1. Connect the cruise control cable slug to the ribbon buckle.
  2. Insert the cruise control cable into the cruise control module until the seal touches the module.
  3. Position the narrow cable tab into the narrow slot and the wide tab into the wide slot.
    4. IMPORTANT: The adjuster tab must be pointing toward the front of the car after installation.
    Fig 2: Aligning Cruise Control Cable
    GM329483Courtesy of GENERAL MOTORS CORP.
  4. Connect the cruise control cable to the cruise control module by turning the cable clockwise.
  5. Install the cruise control cable to the retainer clip on the engine.
  6. Install the cruise control cable to the throttle body bracket pressing into place until fully seated.
  7. Open the throttle body cam slightly.
  8. Connect the cruise control cable to the throttle body cam lever.
    Fig 3: View Of Cruise Control Cable At Throttle Body Cam Lever
    GM792955Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals