LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2004 >> Vibe Base, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (Introduction) - 1.8L (LV6) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: CKP Sensor And Hold Down Bolt
    GM181701Courtesy of GENERAL MOTORS CORP.
  1. Install the CKP sensor (1) into the front cover of the engine block.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the CKP sensor hold down bolt (2).

    Tighten:  Tighten the hold down bolt to 9 N.m (80 lb in).

  3. Connect the CKP sensor electrical connector.
    4. Fig 2: Stone Shield, Bolts And Retainers
    GM830841Courtesy of GENERAL MOTORS CORP.
  4. Install the stone shield (1) with the four retainers (2).

    Tighten:  Tighten the two shield bolts to 10 N.m (89 lb in).

  5. Secure the stone shield (1) with the two bolts (3).
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals