LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Wiper System And Washer System) >> Repair Instructions >> Wiper Drive System Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the wiper drive system module to the vehicle.
  2. Connect the wiper motor electrical connector.
  3. Rotate the wiper drive system module to the mounting position.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the wiper drive system module screws.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

    5. Fig 1: Wiper Drive System Module Screws
    GM815220Courtesy of GENERAL MOTORS CORP.
  5. Install the wiper transmission link to the wiper motor crank arm using the J 39529  . See Special Tools and Equipment .
  6. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
  7. Inspect the wipers for proper operation.
scientia non olet · About LEMON Manuals