LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Antilock Brake System And Traction Control System) >> Repair Instructions >> Traction Control Switch Replacement (Impala) >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. If equipped with column shift, apply the parking brake.
  2. If equipped with column shift, position the transaxle shift control indicator to 1.
  3. Adjust the steering wheel for access.
  4. Remove the ignition switch cylinder bezel.
  5. Remove the LH instrument panel (IP) fuse block access opening cover.
  6. Remove the LH IP cluster trim plate screws.
  7. Remove the IP cluster trim plate for access. Start at the left side of the IP cluster trim plate, grasp the trim plate and carefully pull rearward. Disengage enough IP cluster trim plate retainers in order to gain access the traction control switch.
  8. Disconnect the electrical connector (1) from the traction control switch (2).
    9. Fig 1: Disconnecting Traction Control Switch Electrical Connector (Impala)
    GM814203Courtesy of GENERAL MOTORS CORP.
  9. Remove the traction control switch (1) from the IP cluster trim plate (2).
    10. Fig 2: Removing Traction Control Switch From Cluster Trim Plate (Impala)
    GM814200Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals