LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Antilock Brake System And Traction Control System) >> Repair Instructions >> Traction Control Switch Replacement (Monte Carlo) >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the traction control switch to the floor console trim plate.
    2. Fig 1: Installing Traction Control Switch To Floor Console Trim Plate (Monte Carlo)
    GM578676Courtesy of GENERAL MOTORS CORP.
  2. Connect the electrical connector to the traction control switch.
  3. Carefully install the floor console trim plate. Make sure all of the retainers are fully engaged.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the floor console trim plate screw (1).

    Tighten:  Tighten the floor console trim plate screw to 2 N.m (18 lb in).

    5. Fig 2: Locating Front Floor Console Trim Plate Screw (Monte Carlo)
    GM578742Courtesy of GENERAL MOTORS CORP.
  5. Position the transaxle shift control lever to Park.
  6. Install the center console mat.
  7. Release the park brake.
scientia non olet · About LEMON Manuals