LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Control System 3.8L (Introduction)) >> Repair Instructions >> Knock Sensor (KS) 2 Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Hot engine coolant may cause severe burns. Although the cooling system has been drained, coolant still remains in the engine water jacket. This coolant will drain with the removal of the knock sensor.
  1. Remove the transaxle. Refer to TRANSMISSION REPLACEMENT .
  2. Drain the cooling system. Refer to Draining and Filling Cooling System in Engine Cooling.
  3. Remove the bolts (2) from the knock sensor heat shield (1).
  4. Disconnect the knock sensor electrical connector (3) from the knock sensor.
  5. Remove the knock sensor (4).
    6. Fig 1: Removing KS Sensor (2)
    GM381311Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals