LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Control System 3.8L (Introduction)) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement (L67) >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the MAP sensor.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the MAP sensor screws.

    Tighten:  Tighten the screws to 5 N.m (44 lb in).

  3. Connect the MAP sensor electrical connector and the vacuum hose.
  4. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical 3.8L.
    5. Fig 1: Installing MAP Sensor (L67)
    GM12345Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals