LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Rear Suspension System) >> Repair Instructions >> Spindle Rod Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the spindle rod (5) to the vehicle.
  2. Install the spindle rod (5) to the knuckle (8).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the spindle rod to knuckle bolt (4) and nut.

    Tighten:  Tighten the nut to 150 N.m (110 lb ft).

    4. Fig 1: Installing Spindle Rod
    GM803927Courtesy of GENERAL MOTORS CORP.
  4. Install the spindle rod to the rear suspension support.
  5. Install the bolt (1) and nut to the rear suspension support.

    Tighten:  Tighten the bolt to 140 N.m (103 lb ft).

    6. Fig 2: Installing Bolt & Nut To Rear Suspension Support
    GM614974Courtesy of GENERAL MOTORS CORP.
  6. Install the rear suspension support. Refer to Support Replacement .
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  8. Lower the vehicle.
  9. Adjust the wheel toe angle. Refer to Wheel Alignment Specifications (Front) or Wheel Alignment Specifications (Rear) in Wheel Alignment.
scientia non olet · About LEMON Manuals