LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 74 (Cellular Communication System) >> Repair Instructions >> Bracket Replacement - Vehicle Location Antenna Module >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the communication interface module to the vehicle location antenna module bracket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the communication interface module screws.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    3. Fig 1: View Of Antenna Module Bracket
    GM1202535Courtesy of GENERAL MOTORS CORP.
  3. Align the vehicle location antenna module bracket to the locator on the I/P carrier (cross car beam).
  4. Start the bolts by hand to avoid cross threading. Install the vehicle location antenna module bracket bolts (3, 4, 5).

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    5. Fig 2: View Of Vehicle Location Antenna Module Bracket Bolts
    GM1204600Courtesy of GENERAL MOTORS CORP.
  5. Install the I/P trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) in Instrument Panel, Gages, and Console.
scientia non olet · About LEMON Manuals