LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Seat System) >> Repair Instructions >> Seat Back Replacement - Front >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the seat back frame on the adjuster covers.
  2. If equipped, slide the lumbar electrical connector back in place.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the bolts that secure the seat back to the adjuster.

    Tighten:  Tighten the bolts to 24 N.m (18 lb ft).

    4. Fig 1: Front Seat Back Frame Bolts
    GM865006Courtesy of GENERAL MOTORS CORP.
  4. Install the seat pan.
  5. Install the 4 bolts that secure the seat pan to the adjuster.

    Tighten:  Tighten the bolts to 24 N.m (18 lb ft).

    6. Fig 2: Front Seat Pan Bolts
    GM865020Courtesy of GENERAL MOTORS CORP.
  6. Install the seat pad and trim cover together. Refer to Seat Cushion Cover Replacement - Front .
  7. Install the front seat trim panel. Refer to Trim Panel Replacement - Front Seat .
  8. Install the front seat. Refer to Seat Replacement - Front Bucket .
    9. Fig 3: Rear Cousin Cover (Front Seat)
    GM865021Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals