LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Side Impact Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove any dirt, grease, or other impurities from the mounting surface.
  2. Position the inflatable restraint side impact sensor by the door.
    3. Fig 1: Identifying Side Impact Sensor (SIS) Connector
    GM834331Courtesy of GENERAL MOTORS CORP.
  3. Connect the side impact sensor connector (4).
  4. Install the CPA (3) to the side impact sensor connector (4).
    5. Fig 2: View Of Inflatable Restraint Side Impact Sensor (SIS)
    GM863414Courtesy of GENERAL MOTORS CORP.
  5. Install the side impact sensor (1) to the door (4).
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Align the locating pin on the sensor (1) to the opening in the door (4).

    Begin tightening the side impact sensor bolts (2).

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  7. Install the water deflector to the door.
  8. Install the door trim panel. Refer to Trim Panel Replacement - Side Front Door in Doors.
  9. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 2 , or SIR Disabling and Enabling Zone 6 .
scientia non olet · About LEMON Manuals