Installation Procedure
- Install the driver side air bag (3) to the seat while guiding the air bag wiring harness (2) through the trim cup.
- Install the air bag fasteners (1).
Tighten: Tighten the fasteners (1) to 10 N.m (89 lb in).
- Gently pull the air bag wiring harness (2) down into the seat cushion while guiding the harness through the wire triangle of the seat frame.
- Install the harness retaining clips to the seat frame.
- Install the seat back cover. Refer to Seat Back Cover Replacement - Front in Seats.
- Connect together the J-clip that is along the lower rear seat back.
- Install the driver seat. Refer to Seat Replacement - Bucket in Seats.
- Enable the SIR system. Refer to SIR Disabling and Enabling Zone 7 .
NOTE:
Refer to Fastener Notice in Cautions and Notices.