LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System >> Repair Instructions >> Inflatable Restraint Side Impact Module Replacement - RH >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Alignment Of Air Bag Wiring Harness
    GM628421Courtesy of GENERAL MOTORS CORP.
  1. Install the passenger side air bag (2) to the seat while guiding the air bag wiring harness (3) through the trim cup.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the air bag fasteners (1).

    Tighten:  Tighten the fasteners (1) to 10 N.m (89 lb in).

  3. Gently pull the air bag wiring harness (3) down into the seat cushion while guiding the harness through the wire triangle of the seat frame.
  4. Install the harness retaining clips to the seat frame.
  5. Install the seat back cover. Refer to Seat Back Cover Replacement - Front in Seats.
  6. Connect together the J-clip that is along the lower rear seat back.
  7. Install the passenger seat. Refer to Seat Replacement - Bucket in Seats.
  8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 9 .
scientia non olet · About LEMON Manuals