General Specifications
General Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Differential Bearing Preload | 0.1-0.15 mm | 0.004-0.006 in |
| Differential Carrier Rotating Torque | 1.5 N.m | 13 lb in |
| Drive and Drivenshafts Gears Backlash | 0.2-0.3 mm | 0.0078-0.0118 in |
| Drivenshaft Rotating Torque | 1.5 N.m | 13 lb in |
| Driveshaft Bearing Preload | 0.15 mm | 0.006 in |
| Driveshaft Rotating Torque | 1.5 N.m | 13 lb in |
| Extension Housing Gear Oil Fill Quantity | 290 ml | 9.80 oz |
| Gear Ratio Front-to-Rear | 1.013:1 | |
| Idler Gear Bearing Preload | 1.02-1.78 mm | 0.004-0.007 in |
Extension Housing Shim Calculation Table - Procedure A
| Calculation | Comment | Metric | English |
|---|---|---|---|
| Actual Measurements | |||
| A | A = Nominal or "Given" Value | 57 mm | 2.24 in |
| -B | Subtract B = Pinion Thickness | ||
| +C | Add C = Pinion Installed Height | ||
| -D | Subtract D = Driveshaft Housing Calculated Value | ||
| +/- | Add or Subtract the Plus, Minus, or Zero Value Etched on the End of the Driveshaft | ||
| = Extension Housing Shim Thickness | |||
Extension Housing Shim Calculation Table - Procedure B
| Calculation | Comment | Metric | English |
|---|---|---|---|
| Actual Measurements | |||
| C | Pinion Installed Height | ||
| +E | Add E = Measured Value on the End of the Drivenshaft | ||
| F | C plus E equals F, the Pinion Calculated Height | ||
| D | Driveshaft Housing Calculated Value | ||
| -F | D minus F equals the Extension Housing Shim Thickness | ||
| = Extension Housing Shim Thickness | |||