Scan Tool Data Definitions
- Accessory Relay Command
-
The scan tool displays On/Off. The state of the accessory relay within the body control module (BCM).
- Auto Door Locks Mode
-
The scan tool displays Enabled/Disabled. This is the state of the auto door locks Personalization function as programmed into the driver information center (DIC) Refer to Personalization Description and Operation .
- Auto Door Unlock Method
-
The scan tool displays Key/Park. This is the method in which the auto door unlock function is activated as programmed into the DIC. Refer to Personalization Description and Operation .
- Auto Door Unlock Mode
-
The scan tool displays None/Driver/All/Invalid. This is the state of the auto door unlock Personalization function as programmed into the DIC. Refer to Personalization Description and Operation .
- Battery Voltage
-
The scan tool displays 9.0-15.5 volts. The state of the battery voltage supplied to the BCM.
- Door Ajar Switch
-
The scan tool displays Door Closed/Door Ajar. The passenger door ajar switch input to the BCM, where an open door is displayed as Door Ajar.
- Door Cylinder Switch
-
The scan tool displays Idle/Lock/Unlock. The door cylinder switch input to the BCM, where a cylinder activation is displayed as either Lock or Unlock.
- Door Cylinder Switch
-
The scan tool displays 9.0-15.5 volts. The state of the battery voltage at the door cylinder switch. When the door cylinder switch is active, the voltage displayed drops.
- Door Lock Switch
-
The scan tool displays Idle/Lock/Unlock. The door lock switch input to the BCM, where a lock switch activation is displayed as either Lock or Unlock.
- Door Lock Switch
-
The scan tool displays 9.0-15.5 volts. The state of the battery voltage at the door lock switch. When the switch is pressed, the voltage displayed drops.
- Driver Door Ajar Switch
-
The scan tool displays Door Closed/Door Ajar. The driver door ajar switch input to the BCM, where an open door is displayed as Door Ajar.
- Driver Door Lock Actuator Command
-
The scan tool displays Idle/Lock/Unlock/Invalid. The state of the driver door lock actuator output, where a driver door lock actuator activation is displayed as either Lock or Unlock.
- Key Lock/Unlock Enable
-
The scan tool displays Enabled/Disabled. The state of the door cylinder lock Personalization function.
- Passenger Doors Lock Actuator Command
-
The scan tool displays Idle/Lock/Unlock/Invalid. The state of the passenger door lock actuators outputs, where a passenger door lock actuator activation is displayed as either Lock or Unlock.
- Rear Defog Relay Command
-
The scan tool displays ON/OFF. The state of the rear defog relay within the BCM.
- Rear Defog Switch
-
The scan tool displays ON/OFF. The rear defogger switch input to the BCM, where a switch activation is displayed as ON.