LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> G6 Base >> Repair and Diagnosis >> Electrical >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Ignition Switch Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of Ignition Switch Bracket
    GM1207709Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition switch bracket.
  2. Install the theft deterrent control module. Refer to Theft Deterrent Control Module Replacement in Theft Deterrent.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the ignition switch bracket screws.

    Tighten:  Tighten the screws to 5 N.m (44 lb in).

    4. Fig 2: View Of Ignition Switch Assembly
    GM1207704Courtesy of GENERAL MOTORS CORP.
  4. Install the ignition switch.
  5. Tighten the ignition switch screws.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

  6. Connect the park lock cable at the ignition switch. Refer to Park Lock Cable Replacement in Automatic Transaxle - 4T40-E/4T45-E.
  7. Install the theft deterrent control module wire harness connector.
  8. Install the ignition switch wire harness connector.
  9. Install the ignition switch lock cylinder. Refer to Ignition Switch Lock Cylinder Replacement .
  10. Install the I/P center trim panel. Refer to Trim Panel Replacement - Instrument Panel (I/P) Center .
  11. Install the knee bolster. Refer to Knee Bolster Replacement .
  12. Install the I/P cluster. Refer to Instrument Panel Cluster (IPC) Replacement .
scientia non olet · About LEMON Manuals