Scan Tool Data Definitions

The scan tool displays 6.5-16.5 volts. The amount of battery voltage available at the Power Steering Control Module (PSCM).

The scan tool displays ambient temperature to 135°. The estimated power steering system temperature calculated from a combination of commanded motor current, voltage levels and input from a temperature sensor internal to the PSCM.

The scan tool displays 0-65 amps. The amount of current the PSCM is commanding to the power steering motor.

The scan tool displays 14.20 to -14.20 N.m (10.50 ft-lbs), the amount of torque being applied to the steering column shaft. A positive value indicates a right turn, a negative value indicates a left turn.

The scan tool displays 0.0-5.0 volts, the amount of signal voltage from the steering wheel position sensors signal 1 circuit.

The scan tool displays 0.0-5.0 volts, the amount of signal voltage from the steering position sensor's signal 2 circuit.

The scan tool displays 1, or 2. The number of the steering tuning selected for the vehicle. Electric power steering (EPS) requires different tuning for different levels of assist depending on vehicle content. Steering tuning 1 is for vehicles with a 4 cyl engine, steering tuning 2 is for vehicles with a 6 cyl engine, steering tuning 3 is for the extended sedan.

The scan tool displays 562° to -562°. The amount of degrees the steering wheel has been turned from center. A positive value indicates a right turn, a negative value indicates a left turn.

The scan tool displays 0.25-4.75 volts, the amount of signal voltage from the torque sensor's signal 1 circuit.

The scan tool displays 0.25-4.75 volts, the amount of signal voltage from the torque sensor's signal 2 circuit.

The scan tool displays 0-255 km/h (0-158 mph), the actual speed of the vehicle.