Installation Procedure

Fig 1: Removing Control Cable Grommet

Courtesy of GENERAL MOTORS CORP.

Guide the control cable through the pass-through in the dash panel.
Secure the control cable grommet by pressing the cable into the pass-through hole in the dash panel.

Fig 2: Removing Cable From Control Cable Bracket

Courtesy of GENERAL MOTORS CORP.

Install the control cable into the transmission bracket, push down until the tabs lock the cable to the bracket.

Fig 3: Disconnecting Control Cable From Transaxle Range Switch Lever

Courtesy of GENERAL MOTORS CORP.

Install the cable to the transmission range switch lever by pressing down until the cable snaps into place.

Fig 4: Pressing Tabs On Control Cable And Removing Cable From Control Assembly

Courtesy of GENERAL MOTORS CORP.

Connect the control cable end to the control assembly lever.
Connect the control cable to the pin on the control assembly.
Secure the control cable into the control assembly by pushing into place.
Install the console. Refer to Console Replacement in Instrument Panel, Gages, and Console.
Adjust the control cable assembly. Refer to Shift Control Cable Adjustment .