Installation Procedure

Fig 1: Identifying Accelerator Cables

Courtesy of GENERAL MOTORS CORP.

NOTE: Do not route flexible components (hoses, wires, conduits, etc.) within 50 mm (2 in) of moving parts unless flexible components can be securely fastened. This is necessary in order to prevent possible interference and damage to the component.

Install accelerator cable into the vehicle using routing noted during removal.

Fig 2: Removing/Installing Accelerator Cable & Components

Courtesy of GENERAL MOTORS CORP.

Install the snap retainer through the bulkhead.
Connect the accelerator cable (5) in the slot in the accelerator pedal lever (1).
Seat the snap retainer in the accelerator pedal lever.

Fig 3: Identifying Throttle Cable Bracket With Cables

Courtesy of GENERAL MOTORS CORP.

Connect the accelerator cable to the throttle body lever.
Connect the accelerator cable to the accelerator cable bracket.
Connect the cruise control cable to the accelerator cable bracket.
Install the accelerator cable shield, if equipped.
Inspect and check for complete throttle opening and closing positions by operating the accelerator pedal. Also check for proper carpet fit under the accelerator pedal. The throttle should operate freely, without binding, between full closed and wide open throttle.
Install the left instrument panel sound insulator. Refer to Closeout/Insulator Panel Replacement - Left (Outboard) or Closeout/Insulator Panel Replacement - Left (Inboard) in Instrument Panel, Gauges, and Console.