LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Pursuit Base, Standard >> Repair and Diagnosis >> Brakes >> Antilock Brake System And Traction Control System >> Repair Instructions >> Electronic Brake Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Clean the EBCM mating surface of the BPMV (4), with denatured alcohol, or equivalent.
  2. Ensure that the EBCM (3) to BPMV (4) seal is fully seated in the groove on the EBCM (3).
  3. Install the EBCM (3) to the BPMV (4). Use care when aligning the EBCM (3) to the BPMV electrical terminals (4).
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the 4 EBCM-to-BPMV retaining bolts (2). Tighten the bolts in a criss-cross pattern.

    Tighten:  Tighten the bolts to 4.5 N.m (40 lb in).

  5. Connect the electrical connector (1) to the EBCM (3).
  6. If equipped with RPO LSJ, install the throttle body air snorkel.
  7. If a new EBCM was installed, the EBCM must be programmed. Refer to Electronic Brake Control Module Programming and Setup in Programming and Setup.
  8. Turn the ignition switch to the ON position. DO NOT start engine.
  9. Perform the Diagnostic System Check - Vehicle in Vehicle DTC Information.
scientia non olet · About LEMON Manuals