LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Vibe Base, AWD >> Repair and Diagnosis >> Brakes >> Antilock Brake System, Traction Control System & Stability Control System >> Repair Instructions >> Wheel Speed Sensor Replacement - Rear (AWD) >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Speed Sensor And Retaining Bolt
    GM839787Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the wheel speed sensor (2) to the steering knuckle.

    Tighten:  Tighten the rear wheel speed sensor bolt (1) to 8 N.m (71 lb in).

    2. Fig 2: Speed Sensor Bolt And Nut
    GM839777Courtesy of GENERAL MOTORS CORP.
  2. Install the bolt (1) and nut (2) which retains the wheel speed sensor harness to the upper arm and suspension member.

    Tighten:  Tighten the bolt and nut bolt to 5 N.m (44 lb in).

    3. Fig 3: Speed Sensor Harness And Bolt
    GM839772Courtesy of GENERAL MOTORS CORP.
  3. Install the bolt (2) which retains the wheel speed sensor harness (1) to the vehicle.

    Tighten:  Tighten the bolt and nut bolt to 5 N.m (44 lb in).

    4. Fig 4: Electrical Connector
    GM839762Courtesy of GENERAL MOTORS CORP.
  4. Reposition the wheel speed pigtail harness through the body. Install the grommet.
  5. Connect the wheel speed sensor electrical connector (1).
  6. Lower the vehicle.
  7. Install the rear seat bottom and seat back. Refer to Seat Back Replacement - Rear Split Folding in Seats.
    8. Fig 5: Fuel Tank Filler Pipe Protector And Protector Bolts
    GM839756Courtesy of GENERAL MOTORS CORP.
  8. Install the fuel tank filler pipe protector (1). Secure with 3 bolts (2).
  9. Perform the Diagnostic System Check - Vehicle in Vehicle DTC Information.
scientia non olet · About LEMON Manuals