Installation Procedure

WARNING: This page is about a different car, the 2005 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Cruise Control Servo Electrical Connector

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the cruise control servo (1) and bracket to the vehicle. Secure the servo and bracket with the 2 bolts (2).
Tighten: Tighten the cruise control servo mounting bolts to 6.0 N.m (52 lb in).
Connect the cruise control servo electrical connector (3).

Fig 2: View Of Cruise Control Cable At Servo Lever

Courtesy of GENERAL MOTORS CORP.

Install the cruise control servo cable (4) to the servo lever (1) and bracket. Secure the cruise control cable servo cable bracket with the one screw (5).
Install the accelerator control cable (3) to the servo lever (1) and bracket.
Adjust the cable adjusting locknuts (2) to allow slight freedom of movement between the accelerator control cable (3) and the servo lever (1).
Secure the accelerator cable locknuts (2).
Tighten: Tighten the accelerator cable adjusting locknuts to 8 N.m (71 lb in).

Fig 3: View Of Cruise Control Servo Cover

Courtesy of GENERAL MOTORS CORP.

Install the cruise control servo cover (1) make sure the tabs (2) snap in place.