LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2007 >> Grand Prix Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls & Fuel - 3.8L - Introduction (2 Of 2) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Fuel Pump & Sender Assembly Component View
    GM50636Courtesy of GENERAL MOTORS CORP.
  1. Install the new fuel tank pressure sensor (7) to the fuel sender assembly (1).
  2. Connect the fuel tank pressure sensor electrical connector.
    3. Fig 2: Locating Fuel Sender Access Panel
    GM65739Courtesy of GENERAL MOTORS CORP.
  3. Install the fuel sender access panel.
    4. NOTE: Refer to Fastener Notice .
  4. Install the fuel sender access panel nuts.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  5. Install the rear compartment trim panel. Refer to Rear Floor Trim Plate Replacement .
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (RPO LS4) or Battery Negative Cable Disconnection and Connection (RPOs L26/L32) .
scientia non olet · About LEMON Manuals