LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2007 >> Grand Prix Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Programming And Setup - All Systems) >> Repair Instructions >> Body Control Module Programming and Setup >> Passkey 3 Programming Procedures
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Passkey 3 Programming Procedures

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: If any module or device listed is replaced, programming of the module must be done prior to performing the Passkey 3 Programming procedure.

Perform the Immobilizer System Component Programming (Canada) or Immobilizer System Component Programming (North America except Canada) procedure if any of the following components have been replaced:

Refer to Immobilizer System Component Programming (Canada) or Immobilizer System Component Programming (North America except Canada)

IMPORTANT: After programming, perform the following to avoid future misdiagnosis:
  1. Turn the ignition OFF for 10 seconds.
  2. Connect the scan tool to the data link connector.
  3. Turn the ignition ON with the engine OFF.
  4. Use the scan tool in order to retrieve history DTCs from all modules.
  5. Clear all history DTCs.
scientia non olet · About LEMON Manuals