Sunroof Motor/Actuator Replacement
WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
If the sunroof motor/actuator is replaced, the initialization procedure must be performed in the following order:
- Place the ignition switch to the ON position.
- Press and hold the sunroof switch to the CLOSE position until the glass panel stalls at the hard stop position and moves back to the soft stop position.
- Release the sunroof switch.
- Verify sunroof operation. Refer to Sunroof Description and Operation (One Connector System) .
The programming procedure is not complete if one of the following actions occurs before the procedure is complete:
- The sunroof switch is not held in the CLOSE position.
- The ignition switch is turned to the OFF position.
- Battery positive voltage is removed.
- The glass panel did not reach the fully closed position.