Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Install the BCM to the BCM bracket.

Fig 1: View Of BCM

Courtesy of GENERAL MOTORS CORP.

Install the BCM and BCM bracket to the I/P.

Fig 2: View Of BCM Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the BCM screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).

Fig 3: View Of BCM Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Connect the lower BCM electrical connectors. Engage the cam lock.
Install the knee bolster. Refer to Driver Knee Bolster Replacement .
Install the left I/P insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side .

Fig 4: Locating Body Control Module

Courtesy of GENERAL MOTORS CORP.

Connect the upper electrical connector to the BCM. Engage the cam lock.
Install the left I/P outer trim cover. Refer to Instrument Panel Outer Trim Cover Replacement .
Perform the new BCM setup. Refer to Control Module References for programming and setup information.