LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2007 >> Grand Prix Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Anti-Lock Brake System, Traction Control System & Stability Control System) >> Diagnostic Information and Procedures >> DTC C0710 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the steering angle sensor.
  2. Test for less than 1 ohm between the low reference circuit terminal 1 and ground.
    • If greater than the specified range, test for an open/high resistance in the ground circuit. If the circuit tests normal, replace the EBCM.
  3. Ignition ON, verify that a test lamp illuminates between the ignition circuit terminal 2 and ground.
    • If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the EBCM.
  4. Ignition OFF, disconnect the harness connector at the EBCM.
  5. Ignition ON, test for 0 volts between the communication circuit connector X1 terminal 19 and ground.
    • If greater than the specified value, test the communication circuit for a short to voltage.
  6. Test for 0 volts between the communication circuit connector X1 terminal 11 and ground.
    • If greater than the specified value, test the communication circuit for a short to voltage.
  7. Ignition OFF, test for infinite resistance between the communication circuit connector X1 terminal 19 and ground.
    • If not the specified value, test the communication circuit for a short to ground.
  8. Test for infinite resistance between the communication circuit connector X1 terminal 11 and ground.
    • If not the specified value, test the communication circuit for a short to ground.
  9. Test for less than 1 ohm between the communication circuit connector X1 terminal 19 and terminal 3.
    • If greater than the specified range, test the communication circuit for an open/high resistance.
  10. Test for less than 1 ohm between the communication circuit connector X1 terminal 11 and terminal 4.
    • If greater than the specified range, test the communication circuit for an open/high resistance.
  11. Test for infinite resistance between the communication circuit connector X1 terminal 19 and the communication circuit connector X1 terminal 11.
    • If not the specified value, test the communication circuits for a short together.
  12. If all circuits test normal, replace the steering angle sensor.
scientia non olet · About LEMON Manuals