Ignition Coil: Service and Repair

Ignition Coil Replacement

Removal Procedure

1. Disconnect the negative battery cable.
2. Disconnect the spark plug wires from the ignition coil.




3. Remove the ignition coil screws (1).
4. Remove the ignition coil (2).

Installation Procedure

1. Install the ignition coil (2).






Notice: Refer to Fastener Notice in Service Precautions.

2. Install the ignition coil screws (1).

Tighten the screws to 4.5 N.m (40 lb in).

3. Connect the spark plug wires.
4. Connect the negative battery cable.