Circuit/System Testing
IMPORTANT:
Diagnose any ABS related DTCs before attempting this diagnostic.
- Ignition OFF, disconnect the EBCM harness connector and C4 radio harness connector.
- Test for less than 1 volt between the EBCM harness connector terminal 3 and radio harness connector C4 terminal 5.
- If greater than specified value repair short to voltage.
- Test for infinite resistance between the radio harness connector C4 terminal 5 and ground.
- If less than specified value repair short to ground.
- Test for less than 1 ohm between the EBCM harness connector terminal 3 and radio harness connector C4 terminal 5.
- If greater than specified value repair open circuit.
- If all circuits test normal, replace the EBCM.