Test Description
The numbers below refer to the step numbers in the diagnostic table.
- 1: Make sure you perform the I/M System Check before performing this test. Failure to do so may result in difficulty updating the status to YES.
- 2: This step is to run the heated oxygen sensor (HO2S) Heater tests and evaporative emission (EVAP) System tests.
- 3: This step is to run the Catalyst test. The Catalyst test runs during the specified cruise period.
- 4: This step is to set up the Oxygen Sensor (O2S) tests. These tests run during the idle period immediately following a cruise period that meets a minimum calibrated RPM and time period.
- 5: This step is to run the Oxygen Sensor tests and the EVAP Tests. These tests run during the idle period immediately following a cruise period that meets a minimum calibrated RPM and time period.
- 6: Perform the individual system test for any of the systems that do not update to YES.
- 7: The I/M System Status only reports on whether or not a diagnostic has run, not what the outcome of the test was. If any emission related DTC sets after the tests are complete, the DTC will require diagnosis.
Inspection/Maintenance (I/M) Complete System Set Procedure
| Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
| 1 | Did you perform the Inspection/Maintenance (I/M) System Check? | - | Go to Step 2 | Go to Inspection/Maintenance (I/M) System Check |
| 2 |
IMPORTANT:
Once the engine is started, DO NOT turn OFF the engine for the remainder of the procedure until the test is complete.
|
2 minutes | Go to Step 3 | - |
| 3 |
CAUTION:
Refer to ROAD TEST CAUTION
.
IMPORTANT:
In order for the remaining portion of this test to run, the vehicle must operate in the following conditions:
|
- | Go to Step 4 | - |
| 4 |
CAUTION:
Refer to ROAD TEST CAUTION
. In order for the next group of tests to run, the vehicle must operate in the following conditions:
|
- | Go to Step 5 | - |
| 5 |
CAUTION:
Refer to ROAD TEST CAUTION
.
IMPORTANT:
In order for the remaining portion of this test to run, the vehicle must operate in the following conditions:
|
- | Go to Step 6 | - |
| 6 | With a scan tool, observe the I/M System Status display. Did all of the I/M System Status indicators update to YES? |
- | Go to Step 7 | Go to the specific I/M System Set Procedure for the indicated systems |
| 7 | With a scan tool, observe the Emission Related DTC portion of the I/M System Status display. Does the scan tool indicate any Emission Related DTCs set? |
- | Go to Diagnostic Trouble Code (DTC) List - Vehicle | System OK |