LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2007 >> Vibe Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Cellular Communication Systems) >> Repair Instructions >> Bracket Assembly Replacement - OnStar® Module >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Positioning Module Bracket In Vehicle
    GM1530173Courtesy of GENERAL MOTORS CORP.
  1. Position the module bracket in the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install 3 module bracket mounting bolts.

    Tighten:  Tighten the module bracket bolts to 10 N.m (89 lb in).

    3. Fig 2: Connecting Inverter Electrical Connector
    GM1530168Courtesy of GENERAL MOTORS CORP.
  3. Connect the inverter electrical connector (2).
  4. Clip the antenna and module harness (1), to the module bracket.
  5. Install the communication vehicle interface unit. Refer to OnStar® Vehicle Interface Unit (VIU) Replacement .
  6. Install the communication interface module. Refer to Communication Interface Module Replacement .
scientia non olet · About LEMON Manuals