LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2007 >> Vibe Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - Introduction (2 Of 2) >> Repair Instructions >> Heated Oxygen Sensor 1 Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

IMPORTANT: The HO2S 1 comes with an anti-seize coating on the new sensor. Take precautions in order to prevent removal of any of this coating prior to installation.
    Fig 1: Exhaust Manifold And HO2S 1 (FWD)
    GM851383Courtesy of GENERAL MOTORS CORP.
  1. Install the HO2S 1 (1) into the exhaust manifold.
    2. NOTE: Refer to Fastener Notice .
  2. Tighten the HO2S 1.

    Tighten:  Tighten the HO2S 1 to 44 N.m (32 lb ft).

  3. Connect the electrical connector (2) of the HO2S 1.
    4. Fig 2: View Of Engine Top Cover, Plastic Retainers And Fasteners
    GM856569Courtesy of GENERAL MOTORS CORP.
  4. Install the engine cover (1).
  5. Secure the engine cover (1) with the 2 fasteners.

    Tighten:  Tighten the two fasteners to 7 N.m (62 lb in).

  6. Install the 2 plastic retainers.
scientia non olet · About LEMON Manuals